Bearings In Sleeves And Boots
You pick: the sleeved bearing, sometimes listed as a "special agricultural bearing," is a single race radial bearing, 1-9/16" OD x 5/8" ID x 3/4" with a black plastic sleeve surrounding it, measuring 1-13/16" x 1" with a 1/16" wall; the booted bearing measures 1-1/2" OD x just shy of 11/16" ID x 1/2" thick, inside a 1-13/16" black rubber boot with a removable hex ID bushing.SHARE
Never seemed fair to nail the "lazy" tag so permanently on the "Susans" but that probably has no "bearing" on the issue. Also called turntable bearings, they are the square or circular flat ball bearing devices YOU bolt between two flat objects to achieve rotation. Like that spinning center section of a Chinese restaurant table. We had these in surplus once and they were quite popular. To our chagrin, we discovered they could be bought commercially for the same price. So we did. The 4" version is rated for a 300lb. load and the 12" (round) for 1000lbs.
Never seemed fair to nail the "lazy" tag so permanently on the "Susans" but that probably has no "bearing" on the issue. Also called turntable bearings, they are the square or circular flat ball bearing devices YOU bolt between two flat objects to achieve rotation. Like that spinning center section of a Chinese restaurant table. We had these in surplus once and they were quite popular. To our chagrin, we discovered they could be bought commercially for the same price. So we did. The 4" version is rated for a 300lb. load and the 12" (round) for 1000lbs.
These pillow block bearings have 13-gauge steel mounting straps, 4" long x 1-1/8" with 5/16" x 5/8" mounting slots, and a sintered iron ball unit measuring 1-11/16" dia with either a 5/8” ID or 1” ID brass sleeve. The 5/8” ID one has an oil cup on the top; the 1” dia version has a grease fitting in the same place.
These pillow block bearings have 13-gauge steel mounting straps, 4" long x 1-1/8" with 5/16" x 5/8" mounting slots, and a sintered iron ball unit measuring 1-11/16" dia with either a 5/8” ID or 1” ID brass sleeve. The 5/8” ID one has an oil cup on the top; the 1” dia version has a grease fitting in the same place.
Just a real soft name for a hunk of cast iron that holds a sealed bearing. This one measures 3-1/4" wide x 2-3/4" tall x 1-3/4" with a pair of 3/8" mounting holes in the bottom and a 1-15/16" sealed bearing with a 1" ID x 1-3/8" dia x 1-11/32" long bushing with two setscrews to hold a lube-fitting on top.
Just a real soft name for a hunk of cast iron that holds a sealed bearing. This one measures 3-1/4" wide x 2-3/4" tall x 1-3/4" with a pair of 3/8" mounting holes in the bottom and a 1-15/16" sealed bearing with a 1" ID x 1-3/8" dia x 1-11/32" long bushing with two setscrews to hold a lube-fitting on top.
Bring these bearings to bear on your next project. Our supply and variety is constantly rolling over so get ‘em while we got ‘em!. Click on the bearing name to see a large photo of your favorite.
BEARING, 62MM O.D. X 25MM I.D. X 27MM THICK SINGLE ROW RADIAL