Tired of having to hold your old, worn test leads just so to make a connection? Then it's time to upgrade your test bench. Our each is a set of (4) 36" long test leads with 16AWG wire, and booted 3/4" alligator clips on each end. You'll get (1) each in red, black, white and yellow. Also handy for hanging photos in your darkroom and laundry when you run out of clothespins.

This 5-pin socket is already wired with 9" leads in black, red, white, yellow and blue to its quick-disconnect sockets, ready for your 1/4" or 7mm spade terminals. Measures 1-1/4" x 1-1/16" x 1" thick. Matches our 94746 relay.

You get (3) packs of Gardner Bender black heat-shrink tubing, at least (2) different, from our selection of 3/16", 3/8" and 3/4", all 4" long. This is the best way to keep your wires tidy and packed in, and watching that tube shrink into shape is worth the project alone.

Our 4-position terminal block is rated for 300V and measures 3/4" x 5/8" x 5/8" tall with set-screw terminals and a 3.6mm ID. 300V max rating. CSA.

From the electric swamp. Our each is a six-pack of 2” plated alligator clips with screw terminals, waiting for you to shove some 14-18 gauge wire down their throats--or in their necks, we guess.

These 0.1uF ceramic capacitors have potted radial leads of stranded wire and are rated for up to 250V. Measuring 1-1/2" x 1/2", these are older-type capacitors and are probably more for point-to-point wiring, not PCB mounting.

More gators than a University of Florida homecoming. Scroll on down and select from: our 6-piece assortment of 2” electrical clips including (2) each of insulated pliers-type alligator clips, regular insulated alligator clips and booted alligator clips in red and black; our 4-pack of insulated 2-1/4” pliers-type alligator clips rated for up to 10A with 3/8” wide jaws and crimped ends in black and red; our 29” red and black test leads with open alligator clips at the ends; or our 6-pack of plated 1-1/2” alligator test clips, half red and half black, with crimped ends.

Since these springs come in packs of (12), and you get (3) packs, you'll get (36) of these little steel fuse holders. Each spring measures 5/16" OD x 7/32" thick with a 1-3/16" long leg off the end, so it looks like a tiny corncob pipe. Made to mount 1/4" dia fuses on a PC board, the (36) of them are pregnant with potential repurposes, like metallic millipede parts or mounts for putting candles on the side of a birthday cake so you don't ruin the message on top.

Another very small jumper. This jumper wire is only 3" long with brass screw terminals. The wire is 20 gauge stranded copper and the terminal are 3/16" OD, 1/8" ID.

Multi-purpose, plated, center-spring charging clips. You pick; the 2” clips with 3/8” wide jaws for up to 10A, in packs of (4); or the single 4” clip with 3/4” wide jaws rated for up to 50A.