COMMUNICATIONS & ELECTRONICS

We’ve got the mother of all Farpoint® motion lights, and it happens to be the sister of our ever-popular Casablanca-esque garage light. At 1000 lumens, its beautifully bright, with (52) SMD LED lights on (3) panels that throw a 270-degree beam and can rotate 360 degrees. Solar-powered, with a 2400mAh Li-Ion rechargeable battery and an 8-hour run time. Measures 11’’ x 3’’ with a 5.5” solar panel. The motion and light-sensor range is up to 32 feet, dawn to dusk, but there’s also an on/off switch. Put a couple on the outside of your garage or in the back yard because they’re weather-resistant IP4 rated. Each comes with a mounting bracket, which means it can be detached anytime. Easy to install, hardware and instructions included.

This is your basic 10W LED bulb that will put out 800 lumens, the equivalent of a 60W incandescent. Has a standard medium base, daylight color, and it’s dimmable. Best of all, it has a life span of approx 15,000 hours.

We have stumbled across some sweet little LED lighting drivers. They require between 100-277VAC inputs and have outputs of 27-42VDC (40W) and 28-40VDC (30W). Intended to be used with LED replacement lighting. The 40 Watt output driver measures 5-3/4" x 1-3/4" x 1" and has 2 input and 2 output leads. The 30 W output driver measures 12" x 3/4" x 5/8" also with 2 input and output leads. Now go retrofit away!

Our each is a pack of (10) common cathode 5mm dia red/green/blue LEDs. Clear lens, 20mA rated for 100K hour life. 3V supply will work for all. You also get 100 Ohm and 510 Ohm resistors to step down 5 and 12VDC respectively. Luminous intensity is 4,000 mcd.

Brand new 2' x 2' LED panel lights. 3000k (Warm Light) and operates on 120vac with the included driver. These panels fit into standard drop ceiling tiles and only draw 40watts of power making them ideal as replacements for larger fixtures. Surplus Fact: Driver might be different than photo shows. 

Note: Item is not available for expedited shipping. Retail store customers: available by special order only.

Our each here is (5) 5/8” warm white COB LEDs that are insanely bright (think: airport runway) and rated for 200mA at 32VDC. Mounted on PC boards from 3/4” to 1”. Marked for polarity, with solder tabs for power. No lumen rating, but don’t stare at them head-on if you like your retinas because, like we said, they’re awfully bright. And as with all COBs, a heat sink backing is also a good idea.

This warm white COB LED light is awfully cute at 3/8" but don’t let the cuteness fool you--it’s insanely bright. It’s also deeply discounted (normally $10). Mounted on a 3/4” wide 6-leg pinwheel-shaped PC board, it draws 1.3A at its nominal 32VDC, but will work with as low as 24V. Get a good heat sink, too, cuz it can get right hot when it lights up the night. Made in the USA.

This light not only hits the spot—it is the spot. It’s the Feit Electric Performance LED Dimmable BR30 spotlight and its 13W equal 65W in an incandescent bulb. Has a brightness of 750 lumens, in soft white. Measures 3-3/4” across, has a standard base, and a lifetime of 25,000 hours. Estimated energy cost: $1.57 a year. ’Nuff said, right?

This tiny 3 mm LED sits in a 5/32" x 1/4" x 7/32" black-plastic box with PC board mounts. At 2-3 volts it glows green and draws 40 mA.

Clip this rechargeable bike or task light onto the brim of your cap, and then flip it up or down as needed. Has (4) modes: white high or low flood; red high flood or flashing. Powered by a lithium-ion battery that charges in 2:40 hours via a micro USB port. This is the little light you didn’t know you needed until you got it.

That's (5) skidoos better than 23 skidoo, on account of this 22" light strip has (28) white LEDs on it. To ease installation, we've paired it with a power supply driver. Driver measures 5" x 3" x 1-1/2" and is rated at 28VDC. The black and white wires attach to wall voltage, and green is the ground. The other end has a bunch of wires, but the red and black attach to the LED board and the others are for various control functions. But you only need the red and black to run the light strip.

One byte at a time. Or maybe just a nibble if you’re trying to cut back. A nibble is what programmers call half of a byte. It’s also what the folks at Velleman call this Arduino-compatible microcontroller which has all of the pins as a standard Arduino, but the Nibble is enhanced with (4) built-in buttons and (4) blue LEDS for easy prototyping. Plus, it comes fully assembled and pre-programmed with a memory game. Just plug it into your computer’s USB port and you can start having fun and learning right away.

Here's our reason to dance. These LED spotlight bulbs from Infinite Solutions use only 14 watts, but are 100-watt equivalents. 5-3/4" dia.  and 5-1/2" tall from top to bottom. They are dimmable, have an E26 standard medium base and are 3000K. (Think of the top end of the warm white scale.) and are listed to last over 25,000 hours or nearly as long as The Lord of the Rings Trilogy expanded editions. Now go illuminate your space.

This light fixture takeout has (8) 1/16” dia surface-mounted COB LEDs on a 1-7/8” dia circuit board/heat sink. Nominally rated for 1A at 32VDC via a 4mm ID 2-pin Molex connector. Most will have a 3/8” square clear lens over the elements. The lumens are a mystery, but it’s brighter than an MIT physics major. Color temp is warm white.

LEDs in assorted colors and sizes for displays, hobbies, robotics, electronics and more.

Orange and green glow the (40) 3/16" dia LEDs in the 5 x 8 dot-matrix grid. Housing measures 2-3/8" x 1-1/2" x 3/8" thick and the chip draws up to 50mA at 2.5VDC. Comes with a data sheet.

We couldn’t think of any clean jokes for this part, so just add your own. Meanwhile, this little, 1/4” dia, bright white COB LED is mounted on a 3/8” square PC board. Requires 70mA at 9VDC. Our in-house Fire Prevention & Ophthalmology Team suggests a heat sink as well as indirect viewing.

Yes, this is the brightest bulb in the box. Our 120VAC 4.8W COB LED bulb casts a warm white color, and connects via (2) pins to a GU10 base. Lense measures 1-3/8” dia in a 1-7/8” dia surround, and the whole thing measures 3-1/8” long not counting the pins.