This panel-mount, grounded outlet from Eagle Electronics is rated for up 15A at 125V, and measures 1” square. You’ll need 1-1/2” clearance on the back. Has a pair of retaining clips, (2) spade terminals and a ground screw. UL/CSA.

Translated as “I GIVE UP” to an entire generation. Now we have those very keys in size humongous, in white and approx. 6” x 5” x 3” tall, and with internal white LEDs so they act as area or night lights. Push on; Push off. Will sit flat or mount with the included screws and mollies, and run on (3) “AA” batteries, also included. We’ll send you one of each in your pack so you can give a full set to the computer geek in your life.

Yes, you can now take all those hours, days, months and years you spent playing Pac-Man® and convert them to a table lamp that your spouse will hate. The Pac-Man® lamp measures 8-1/4” dia with a remote control (15-foot range) to pick one of (7) brightness levels and (12) authentic sounds from the original game. Includes a wall adapter and battery for the remote.

Here’s a replacement, no-frills power cord for most shavers, boomboxes, TVs, etc. Measures 6-feet long with an 18-2AWG cord, and a 2-pin, shaver plug.

These LEDs are wired with an in-line diode on one leg so you can run them with either AC or DC. 24 volts works best (do not run them on 120V!) drawing 4mA. You'll get leads between 4" and 9" with quick-disconnect terminals. You pick yellow or red.

Don't wait or it'll all be gone. You get (4) pieces, 11 feet each, of 18-2 wire, polarized, black with a white stripe and eminently discardable spade-push terminals on both ends. (That's under a nickel a foot, cowboy.) Lamp cord, speaker wire, pretty much anything you run juice to.

This tiny 3 mm LED sits in a 5/32" x 1/4" x 7/32" black-plastic box with PC board mounts. At 2-3 volts it glows green and draws 40 mA.

Wire up those bowling trophies, or just rewire those lamps with the ugly black cords. You get a package of (4) white 18-2 AWG lamp cords, 48" long, with plugs on one end. Cheap, cheap.

Hay! You need wire? Surely you have something you could bale with all of this 1/16” dia steel baling wire. You’ll get (8) 36” lengths of it. Toss it in the trunk when you need to reattach something to the car that duck tape won’t work on.

Is mighty bright, actually, and warm white. Our COB LEDs are 5/8" dia, mounted on PC boards that measure approx 1-1/8" x 3/4". Nominally rated at 32VDC up to 1A, with heat-sink backings. Best with a constant current supply, which will draw 170mA or use a current limiting resistor and a heat sink.

This little 1-3/8" x 3/4" PC board is wired with (8) surface mounted diodes and attendant components. Draws approx 5mA at 12VDC. Has a pair of solder pads for power, with the left one (or top one, depending on how you’re holding it) being hot. CJ, our Director of Knowing About This Sort of Thing, suggests “good heat-sinking.”

Why curse the darkness when you can light these 120V 30W candelabra bulbs in the electric candelabra you build. Which you can do because each bulb comes in a matching socket, dark brown, 1-1/8" tall x 13/16" dia with steel wings to compress it into a fitting. Each socket is rated for up to 75W and has quick-disconnect terminals on the bottom. UL.

Our each is a 56" length of paired blue and red 18AWG wire with 1/4" quick-disconnect terminals on one end and a 3mm center-to-center polarized plug at the other. Also handy as a hook-up wire.

No need start clapping and look like a fool when you screw in one of these standard bulb sockets with a photocell that will automatically turn on your bulb when the daylight dims. Rated for up to 100W. (May not work with some LEDs.) Good for outdoor use as long as the fixture is shielded.

You decide. This panel-mount indicator light has a 5mm red LED in a 5/16” dia x 3/4” deep mount with 47” leads and a 2-pin 5.5mm Molex connector on the other end. Includes wings on the mount to hold it in place. You'll need 20mA at 3VDC for power.

Very pretty. Very graceful. These clear-glass 2.2 volt, .25 amp bulbs are a wavy, flame shape 1-1/2" tall and 5/8" dia at the widest point. The base is candelabra size. They work fine on 3 volts (2"AA") at .32 amps. Order extras, because we don't think you'll find little pretties like these at your local hardware store.

Power is easier to corral when the cord is coiled. This 12" coiled small-appliance cord will stretch to something like 5 feet. Has a standard 2-prong, ungrounded plug at one end and a 9/16" wide x 5/16" (between the pins) 2-pin socket at the output end (think electric razor). Rated up to 250VAC, with no current listed, but it's for lighter duty. Made, for a change, in Holland.

Magnet wire in assorted colors (our choice). Great for jewelry making, arts & craft projects or any other exotic application. Even if you are just making a garden variety coil or electromagnet you will still find the prices very good.