BEST SELLERS

Orange and green glow the (40) 3/16" dia LEDs in the 5 x 8 dot-matrix grid. Housing measures 2-3/8" x 1-1/2" x 3/8" thick and the chip draws up to 50mA at 2.5VDC. Comes with a data sheet.

Neatness definitely counts. Even in wiring. Especially in wiring. End those electrical mare's nests with this 6-position barrier strip, rated for up to 30A at 600V. Comes with a clear plastic cover with access to the screw terminals and measures 3-5/8" x 1-1/4" x 5/8" with a 5/16" mounting hole at each end. Terminals are in pairs.

This light fixture takeout has (8) 1/16” dia surface-mounted COB LEDs on a 1-7/8” dia circuit board/heat sink. Nominally rated for 1A at 32VDC via a 4mm ID 2-pin Molex connector. Most will have a 3/8” square clear lens over the elements. The lumens are a mystery, but it’s brighter than an MIT physics major. Color temp is warm white.

No, not knives. These are bayonet bulbs, so named because you push them in and twist, just like mounting a bayonet. Our each is a 2-pack of 12V 8W bulbs, most likely for automotive use.

Call us dim bulbs and we won’t argue. We’ll just let you pick from our selection of dimmers. All of them are made for standard electrical boxes, and you'll need 1-3/8” back clearance. All are good with incandescents but not CFLs, and can be used with LEDs, but will then not fade to total black. All include wiring instructions, screws and wire nuts and are UL listed. The dual slide one is for (2) 120V fixtures up to 300W, and has a full-off switch at one end of the faders. The 700W slide dimmer for a light fixture has an SPST rocker switch and is OK for single or 3-way wiring, although multi-gang wiring will be lower wattage. 

5' long, 1" diameter LED cooler lights in cases of 25. At 5000k and 1500 lumens these lights are all the rage. Originally intended as replacements for coolers, (think grocery stores) we think they are perfect for sheds, showcases, garages and even light saber battles. They operate on 36 volts, 22 watts and that means they need an LED driver. You're in luck, we are including the drivers! Each driver measures 1" x 12" long. Housing is plastic with a clear front and plastic ends with holes for mounting. Now go illuminate something. A lot of things!

Jarvis says: Due to size, your entire order will ship standard UPS ground. No expedited shipping.

Let’s say you’ve picked out the perfect shag carpeting, air freshener and Blue Oyster Cult album, but pedestrians are still creeped out when you invite them into your van. This chrome steel dome light, measuring 9” dia and 2” thick, might be just the ticket. Light itself has a 7” clear plastic cover and fits in a 7-1/4” dia hole. A (3)-pin automotive connector on 4” leads juices the (2) bulbs inside. Now that we can see everything, pass us a KitKat and some of that patchouli.

Why curse the darkness when you can light these 120V 10W candelabra bulbs in the electric candelabra you build. Which you can do because each bulb comes in a matching socket, dark brown, 1-1/8" tall x 13/16" dia with steel wings to compress it into a fitting. Each socket is rated for up to 75W and has quick-disconnect terminals on the bottom. UL.

This red plastic tail light measures 3" wide x 2-1/4" tall x 1-1/2" deep (rectangular is the new round) with a 24" power lead. The mounting bolt is meant to be grounded. Draws 50mA at 12VDC. Ideal for trailers, go karts, scooters and DIY robot eyes.

Fancy up your lighting with these flame-shaped LED bulbs. Base is E-14 European-Edison size, and they have a diamond-shaped faux-filiament and vertical cooling slots in copper-colored aluminum around the bottom half. You pick the warm-white 3W (40W equivalent); the cold-white 3W (40W equivalent); or the cold white 5W (60W equivalent). Also, finding E14 to E12 adapters on the web is a snap.

We couldn’t think of any clean jokes for this part, so just add your own. Meanwhile, this little, 1/4” dia, bright white COB LED is mounted on a 3/8” square PC board. Requires 70mA at 9VDC. Our in-house Fire Prevention & Ophthalmology Team suggests a heat sink as well as indirect viewing.

Who doesn’t love laser pointers? Their precision. Their ethereal, mind-blowing, otherwordly glow. Their magic, now-you-see-it-now-you-don’t quality. Ours come in several colors, including red, green, violet and combinations of those. You want a single point? We’ve got ’em. You want a kaleidoscope display? We’ve got those, too. They're all 5" to 6" long, give or take, styles may vary and "AAA" batteries are not included. All you have to do is point and click.

This LED COB light panel operates at 32-36VDC at 500-600mA, (around 20 Watts) and it’s insanely bright. On a 6" square PC board--a takeout from unused medical equipment--has (3) rows of (5) white COB LEDs. Board is coated, and each LED has a 7/16” plastic bubble over it. There are (6) grommeted 3/16” mounting holes. Has clipped-off black and red leads on opposite sides marked for polarity. Approx. 1000 Lumens and 6500K on the color spectrum whitch is daylight.

Jarvis Says: LED drivers can be located here...Click

Yes, this is the brightest bulb in the box. Our 120VAC 4.8W COB LED bulb casts a warm white color, and connects via (2) pins to a GU10 base. Lense measures 1-3/8” dia in a 1-7/8” dia surround, and the whole thing measures 3-1/8” long not counting the pins.

These Aura® Ultra-Slim Lamps are white fluorescent fixtures with two-prong grounded plugs and made to mount under cabinets with the included clips, but they're happy to go anywhere. All have a 1-3/8" x 3/4" profile, a 6-foot cord, and T4 high-efficiency bulbs with a 3100K color temp (a "warm" color rating) with an est. 9K-hour life. All can be connected to run in a series with the jumper cords. You pick fixtures at  12W x 19-1/2", 16W x 21" long, or the 20W x 23" long. ETL listed.

Tired of the same old predictable nightlights? Be the first on your block to have one of these 120V 7W beauties, with a stained glass lampshade and the face of an eagle, bear or wolf poking out of it. Shades measure approx 2-1/2" at their widest x 2-1/2" tall. We’ll pick (2) different heads because we know you love all animals. UL.

This 12V 20W MR-16 halogen bulb has a GX-5.3 2-pin base (yes, the one with the pair of little pins that you see all the time). Throws a 12" spread of light and is rated to stay bright for 2,000 hours, which is certainly more than anyone can say for me.

LEDs in assorted colors and sizes for displays, hobbies, robotics, electronics and more.