Our each is a pack of (10) common cathode 5mm dia red/green/blue LEDs. Clear lens, 20mA rated for 100K hour life. 3V supply will work for all. You also get 100 Ohm and 510 Ohm resistors to step down 5 and 12VDC respectively. Luminous intensity is 4,000 mcd.

These are medium-base dome-shaped LED light bulbs, and in standard English that’s a light-bulb-shaped LED light bulb with a standard light-bulb screw-in bottom. These draw a stingy 15.5 watts but throw the equivalent of a 100W bulb. Instant-on and dimmable with a 25,000-hour life expectancy, and also suitable for damp conditions. Your only job is to pick 3000K soft white, 4000K cool white, or 5000K daylight. UL.

These candelabra-base bulbs draw only 2W but put out the equivalent of a 25W incandescent. Will cast a 2700K, yellow-white color at 170 lumens. In a candle-flame shape, blunt top, 3-1/4” tall and not dimmable. Manufacturer says they’ll last 10 times longer than incandescents, which means nine fewer times you’ll stand on the dining room table to change them.

These LEDs are wired with an in-line diode on one leg so you can run them with either AC or DC. 24 volts works best (do not run them on 120V!) drawing 4mA. You'll get leads between 4" and 9" with quick-disconnect terminals. You pick yellow or red.

This tiny 3 mm LED sits in a 5/32" x 1/4" x 7/32" black-plastic box with PC board mounts. At 2-3 volts it glows green and draws 40 mA.

Is mighty bright, actually, and warm white. Our COB LEDs are 5/8" dia, mounted on PC boards that measure approx 1-1/8" x 3/4". Nominally rated at 32VDC up to 1A, with heat-sink backings. Best with a constant current supply, which will draw 170mA or use a current limiting resistor and a heat sink.

This little 1-3/8" x 3/4" PC board is wired with (8) surface mounted diodes and attendant components. Draws approx 5mA at 12VDC. Has a pair of solder pads for power, with the left one (or top one, depending on how you’re holding it) being hot. CJ, our Director of Knowing About This Sort of Thing, suggests “good heat-sinking.”

You decide. This panel-mount indicator light has a 5mm red LED in a 5/16” dia x 3/4” deep mount with 47” leads and a 2-pin 5.5mm Molex connector on the other end. Includes wings on the mount to hold it in place. You'll need 20mA at 3VDC for power.

We couldn’t think of any clean jokes for this part, so just add your own. Meanwhile, this little, 1/4” dia, bright white COB LED is mounted on a 3/8” square PC board. Requires 70mA at 9VDC. Our in-house Fire Prevention & Ophthalmology Team suggests a heat sink as well as indirect viewing.

Like the smartest kid in class, this little PC board is crazy bright with (8) 1/8” dia warm white LED COBs. Clearly marked pads for power inputs. The whole shebang is just 7/8” dia with 3/32” mounting divots. Requires a heat sink and a current-limiting resistor.