Want to turn your phone or tablet into a storage dynamo? Of course you do -- you've got data! This 5" long cable has a micro USB male fitting at one end and a standard USB female connection at the other, which enables you to use a standard thumb drive on devices that only accept a micro USB. Transfer the 2,738 photos from the picnic off your phone or plug in your USB stick of Yanni music; an On-The-Go data necessity.

Tired of having to hold your old, worn test leads just so to make a connection? Then it's time to upgrade your test bench. Our each is a set of (4) 36" long test leads with 16AWG wire, and booted 3/4" alligator clips on each end. You'll get (1) each in red, black, white and yellow. Also handy for hanging photos in your darkroom and laundry when you run out of clothespins.

Our each is a dozen nickel-plated 2” long steel alligator clips with PVC sleeves but no boots because they’re made for electrical testing or soldering. You’ll get (6) each with red and black sleeves.

Charge, Charge. Or Sync, Sync. Direct from the Valley of Superchargers, these 3-foot USB-A 3.1 to USB-C cords are flat to prevent tangles and will charge or sync your data at 10Gbps, which will leave your standard charging cable standing at the gate. We’ll pick one in black, blue, white or hot pink, which are the hardest to lose.

This 5-pin socket is already wired with 9" leads in black, red, white, yellow and blue to its quick-disconnect sockets, ready for your 1/4" or 7mm spade terminals. Measures 1-1/4" x 1-1/16" x 1" thick. Matches our 94746 relay.

Our 4-position terminal block is rated for 300V and measures 3/4" x 5/8" x 5/8" tall with set-screw terminals and a 3.6mm ID. 300V max rating. CSA.

And move that data with these 3-foot USB to micro-USB charge and data cables. Wires are cased in heavy-duty braided nylon for prevention of kinks and fraying. We’ll select one in red, green, white, blue or black, guaranteed to either complement or contrast with your phone.

More gators than a University of Florida homecoming. Scroll on down and select from: our 6-piece assortment of 2” electrical clips including (2) each of insulated pliers-type alligator clips, regular insulated alligator clips and booted alligator clips in red and black; our 4-pack of insulated 2-1/4” pliers-type alligator clips rated for up to 10A with 3/8” wide jaws and crimped ends in black and red; our 29” red and black test leads with open alligator clips at the ends; or our 6-pack of plated 1-1/2” alligator test clips, half red and half black, with crimped ends.

You get (3) packs of Gardner Bender black heat-shrink tubing, at least (2) different, from our selection of 3/16", 3/8" and 3/4", all 4" long. This is the best way to keep your wires tidy and packed in, and watching that tube shrink into shape is worth the project alone.

These 0.1uF ceramic capacitors have potted radial leads of stranded wire and are rated for up to 250V. Measuring 1-1/2" x 1/2", these are older-type capacitors and are probably more for point-to-point wiring, not PCB mounting.

Once up on a time, when giants stalked the earth and there was no night baseball in Wrigley Field, car phones were the cuttingest-edgiest technology on the planet. Guess who has the antennas. These are passive antennas, 23-1/2" long x 1/16" dia on 1" dia (suctionless) rubber cups.with 5/16" dia copper discs  inside. Perfect for giant insect sculptures or for gluing on your trunk and pretending it's 1983 all over again.

This pair of 3” pliers-style alligator clips for quick wire connections have red and black insulator boots, and are good for up to a whopping 30A. Crimp connections are under the rubber insulators. We'll send you (2) pairs because you can't charge a battery without (4) clips. 

Since these springs come in packs of (12), and you get (3) packs, you'll get (36) of these little steel fuse holders. Each spring measures 5/16" OD x 7/32" thick with a 1-3/16" long leg off the end, so it looks like a tiny corncob pipe. Made to mount 1/4" dia fuses on a PC board, the (36) of them are pregnant with potential repurposes, like metallic millipede parts or mounts for putting candles on the side of a birthday cake so you don't ruin the message on top.

These black-plastic brackets with (2) 1/8” mounting holes are designed to hold the IEC jack on a computer. The bracket for a flush mount has locking tabs, inside dimensions of 1–3/32” x 13/16” plus side slots, and will stand 1/8” off the panel. The bracket for a recessed mount has locking tabs, inside dimensions of 1–1/16” x 3/4” plus side slots, and a 3/16” deep well. The swivel bracket is 2” x 1–1/16” x 1–1/2” OA and includes a strain relief that can swivel 180°.

It’s a sweater in England, but here it’s a 4" double cord with a molded female 1/8” standard headphone jack at one end, and molded left-right (white-red) male RCA jacks on the other.

Multi-purpose, plated, center-spring charging clips. You pick; the 2” clips with 3/8” wide jaws for up to 10A, and we'll send you (2) packs of (4) for a total of (8). (Isn't math fun?). Or pick the 4” clip with 3/4” wide jaws rated for up to 50A, sold straight up in packs of (2). 

Time was, these were sticking through the trunk of every 1984 Taurus on the planet. Now the car phone is mostly a memory, but you can own the antennas for a song. These are passive, 13" long with the bottom 2-1/2" in a coil and a ferrite choke halfway up. Base has a 5/32" - 24 thread.

Standard-sized, white-plastic wall plates for permanent A/V wiring. The (3) color coded female RCA terminals will let you get rid of that unsightly tangled rat's nest of cables on the floor and cleanly and neatly run them through the walls. You deserve that video screen and stereo speakers in the bathroom after all.