BEST SELLERS

Gadgeteers, get out your charge card. This is an instrument you absolutely have to own. It reaches down below sofa cushions, inside piggy banks, into fish tanks, and past a gallbladder. Not simultaneously, of course. The slim stainless steel alligator forceps is 10-1/4" long OA, with a 3" angled handle and an 7-3/4" reach. It has small 3/4" long tapered serrated jaws that measure approx. 1/8" wide x 3/16" at the largest and open to a max width of approx 3/8" or 10mm, in a delicate but tight fashion at the tip! Better buy an extra. We guarantee people are going to "borrow" these if they see them.

Life will never be dull again if you carry this pocket-sized diamond knife and scissors sharpener. Comes with (3) 2" long diamond encrusted rods, (2) medium coarse and (1) fine. The 1-15/16" x 2-3/8" x 5/8" holder is also a frame with slots that hold the rods at the correct blade-sharpening angle. Even though it's made as a pocket tool, with a short keychain, it would abrade its way right out of any pocket. We recommend you just hang it above your workbench.

And we did it ourselves with this self-healing cutting mat. It's hard rubber and no, we don't know how it heals itself, but it does. Measures 11-3/4" x 8-3/4" x 1/8" thick., it's marked in 1/8" and 5mm increments and 1/2" squares, with lines for 45° and 60° cuts.

Sounds like an Olympic figure-skating move, the standing, self-closing reverse tweezer, but it's really a tweezer that's closed until you squeeze it. It also has a frame to hold it up off a work surface, so it doubles as a vice. Ours have wooden grips and measure 6-3/8" long with 2-7/8" serrated jaws and a 2" x 1-1/2" stand.  

And we do mean micro. Sizes #61 to #80 (yes, that is twenty different bits) which are from 0.013 to 0.038 inches diameter!! The big boys sell a set of similar bits (carbon steel, like ours) for about $30.00!! Maybe theirs aren't from China.

Hey, need a hand with that? Of course you do, and thanks to the “Helping Hand with Magnifier,” you’ll always have one. Ideal for working on electronic PC boards, small devices, and elaborate sandwiches. Has a heavy cast-iron base for stability with a divot for holding parts, and includes a 5” pivoting bar with (2) rubber-coated gator clips, all adjustable. The 3-1/2”-dia magnifying glass makes tiny parts, including olive garnishes, totally clear. The Addams Family wishes it had one of these instead of Thing! All for under 8 bucks? Somebody deserves a hand.

More likely cowskin, but who ever says that? Leather, anyway. Our each is a package of (10) leather cords, 3/16” x 1/16” x approx 42” long, in assorted colors and ready for your frontier craft needs, or for lacing up your boots. Also dandy for cowboy key chains. Our samples were brown, dark brown and black. What will yours be?

Donut magnet you can take to town!! 74mm dia. x 14mm thick with a 30mm hole. Very strong and well pedigreed - in fact, its kin are activating pacemakers. They are of a high permeability ferrite material with a lovely light blue or white epoxy coating. Okay, we have them because there is the odd bubble, slight scratches or the word MAGNET painted in the coating which ruled them out of the medical ball, but they're fine company nonetheless. Good display bases, paper clip traps, and super for classroom demos.

Our each is 100 feet of of paracord (tactical cord) from Atwood Rope Mfg. Measures 3/32" dia (think round shoelace) with (4) internal strands and a 275-lb test strength. UV inhibited; rot and mildew resistant. In assorted solid and blended colors, from which we'll pick because we have impeccable taste in cordage.

Winner of this week's "What IS That?" award. It's a watch crab, also called a spanner wrench, that's designed to remove the back from watches, lenses from telescopes, and other thin, flat components from whatever they're attached to. Heavy for its size, it's 1" x 2-3/4" x 3/8" thick, with sharp 1/4" prongs projecting from the edge. The prongs move from 2" to 7/16" apart as you spin the knurled nut between them. An impressive tool to flash in front of your brother-in-law. If he doesn't read our catalog, he won't have a clue!

This 5-pack of 24" multi-strand elastic bungee cords aren’t High Definition—they’re Heavy Duty. Cords measure 3/8” dia with sturdy metal hooks that are 9/64” dia thick and 2-1/8" long with 3/4" inner dimensions and rubber caps on the ends. Outer cloth is black with green flecks. These serious bungees are great for autos, trucks, ATVs, motorcycles, campers, boats and household use. Keep some on hand. You always find uses for good bungees.

Hydroponic scissors. Yeah, a first for us, too, but these Titanium-bonded, non-stick, precision-ground scissors are corrosion- and adhesion-resistant, with soft, flexible handles. Short, 1-3/4” long blades, like bonsai folks use, except these are made for people who grow Boston bibb lettuce without dirt. Paul the buyer assures us, however, that these scissors won't know or care if you use them to open bags of nacho chips.

And then give us a little tweeze, and a couple more for luck. Our 4-piece stainless steel tweezer set includes: 4-5/8" long bent tweezers; 4-1/2” fine point; 4-5/8” cross-locks; and 4-1/4” blunt-tip stamp tweezers with 1/4” wide tips for you philatelists.

Pop one of these roughly 1-1/4" dia stones into the toe of a sock, smash it with a hammer, and be the first person ever to see your real-as-Nature-makes-it geode!! Ninety percent of them have the familiar beautiful white crystals inside. Formed by volcanic action, they are found all over the world, but ours are from Mexico. There is no way to tell from the outside if they have crystal centers, but we will send you two just to raise your odds, and we haven't had a dud yet in our stores!! Much much more fun and satisfaction than buying one already cracked.

One of your favorites is back! Make your own custom clock in a tick with this quartz movement. It's in a 2-3/16" square x 5/8" thick black-plastic case. Comes with black minimalistic hour and minute hands and a red second hand, the latter (2) of which will extend out 2" from the clock's center; the shaft measures 5/16" Dia. and 1/2" long, but the max. thickness of material it will work through is 3/16". Now offering two ways to mount with the included double-sided foam adhesive and metal bracket with hanging hook. You supply (1) "AA" battery and the clock face.

It's officially a watch-case holder, and indispensable for jewelers and watch collectors, but it's equally useful for holding anything small and squirrely while you work on it. A pair of 1-3/4" long x 15/16" tall brackets have (4) sets of (6) holes that take (4) movable posts. Spring-loaded jaws dial open to a max of 1".

Just the one, actually, but it’s been sliced in half so the pair is perfectly symmetrical and mighty pretty. Although ammonites have been extinct for 65,000,000 years, we’ve got their approx 1” dia fossils for you. Our each is a book-matched pair of polished ammonites fossils of a single critter halved and polished to a bright symmetrical shininess. The colors vary from light tan to dark brown and we’ll pick because we have impeccable ammonitical color-shade taste. And yes, they’re just screaming to become cuff-links or earrings.

Any way you want it. This cast aluminum wire jig for jewelry-making measures 4-3/8" x 1" x 5/8" with (4) 1” x 1/4” steel pegs, semi-circular and triangular bending points, slots at 3/32",1/8" and 3/16" wide, plus one with a small divot to one side. Includes mounting screws so you can stick it to your workbench. Not into jewelry? Bend your own fishing hooks, S-hooks and soft metal strips.